2014 Isuzu Tipper with Aggregate Spreader attachment
• Supply of a New 2014 Isuzu CXZ 415 GIGA PREM
• 309KW @ 1800RPM
• GVM- 24,000KG
• GCM -54,000KG
• ISUZU 12 speed Automated Manual Transmission (AMT)
• 4.5m x 2.5m ( hardox ) tipper
• approx 11cubic meter
• 2 way tail gate and air operated.
• front body hoist
• Certified FOPS (Roll Over Protection System)
• Spare wheel to cab rack
• Electric winch for spare wheel
• Revolving Light to Ropes
• High Rise LED lights to ROPS
• 9kg Fire extinguisher mounted to module 1.5Kg Extinguisher in cab
• Lock safe battery isolator to be fitted to truck
• Canvas seat covers
• Orange Safety Flag/Whip Aerial.
• UHF radio
• 12V & 24V jump start receptacles
• Emergency stops 1 x inside the cab and 1 x outside the cab
• Wheel chocks mounted in holding bracket
• Emergency Stop (inside and outside)
• Safety Triangles
• Work Lights to rear of cab
• Mine Spec Reversing Alarm.
• Headlights (Low Beam) wired on with Ignition.
• First Aid Kit in Cab.
• Spill Kit in Cab.
• 75mm Hi-VIS Striping to Cab and tipper
• Tool Box
• Grease Lines to front end
• PH300 pintle hook with trailer brakes
• Supply of one New Aggregate Tail Gate Spreader Box
Standard Paintwork is Highway Yellow. Unit weight is 330kg.
• Tipper Body Mounting Brackets.
• Eight independent door openings of approximately 332mm width with individual electric over air actuators to open and close doors to pre-set openings for various grades of material.
• Patented 6,800Nm Electric Linear Actuator, 12VDC or 24VDC, providing controlled gate-opening adjustment settings from Cab.
• In Cab Control by the Driver to increase gate opening during the run, if required with Digital Indicator of Gate Opening Position. Adjustable Gate Openings from 0 to 90mm.
• Remote Electric over Pneumatic Control with Integral Air Receiver with Filter, Regulator and Drain Valve. Control of 8 individual gates by an External Operator with Hand Held Remote Control. Gates can be opened and closed from the Cab in any configuration. Individual Gate Adjustment Bolts are fitted.
• The Body of the MBE Spreader is manufactured from Laser Cut 4mm Mild Steel Sections with tongue and groove position welded construction, insuring uniform dimensions and fit. The Gates are of MBE Curved Pivot Design with all pivot points fitted with grease nipples for trouble free operation. This design eliminates the problems of the previous sliding gate designs which were prone to jamming.
• An aggregate dribble guard of swing away design is fitted to avoid spillage of material while travelling and is fitted with a manual lock.
• The unit is fitted with 4 adjustable RHS legs for floor mounting when detached from the Tipper Body.
• Fitting to your vehicle your care with Support Chains the cost of Hydraulic Ram & Anchor Hooks would be your care.
For further information, please do not hesitate to contact on
**AGGREGATE SPREADER IS NOT INCLUDED IN THE PRICE SHOWN**
*Government Charges are not included, and may vary per state*